On this occasion, we are going to repair a fault that affects the BMW 3
series with M57 and M57N diesel engine.
SYMPTOMS
The engine malfunctions during different operating phases, for example, while accelerating, on starting the engine from cold and/or when travelling at a constant speed at low rpm.
After carrying out a diagnostic reading, no fault code can be seen recorded relating to the engine problems.
One of the causes of this anomaly is that there is a deterioration in the fuel rail sensor connector or in the sensor wiring.
SYMPTOMS
The engine malfunctions during different operating phases, for example, while accelerating, on starting the engine from cold and/or when travelling at a constant speed at low rpm.
After carrying out a diagnostic reading, no fault code can be seen recorded relating to the engine problems.
One of the causes of this anomaly is that there is a deterioration in the fuel rail sensor connector or in the sensor wiring.
CHECKS
To carry out a repair, check to see if a fault code has been recorded with a diagnostic tool. Then carry out an injector correction reading to verify that one of the injectors has an incorrect value and rule out possible problems. At this point, check that on moving the pressure sensor connector by hand, the engine provides an easily perceptible positive response.
After the above results, the connection problem is shown to be in the fuel rail pressure sensor. To resolve this incident, the fuel rail pressure sensor wiring should be removed and replaced with a specific kit from the manufacturer.
To carry out a repair, check to see if a fault code has been recorded with a diagnostic tool. Then carry out an injector correction reading to verify that one of the injectors has an incorrect value and rule out possible problems. At this point, check that on moving the pressure sensor connector by hand, the engine provides an easily perceptible positive response.
After the above results, the connection problem is shown to be in the fuel rail pressure sensor. To resolve this incident, the fuel rail pressure sensor wiring should be removed and replaced with a specific kit from the manufacturer.
No comments:
Post a Comment